AIConnectors.io
ChatGPT logo
+

ChatGPT +
CurbWaste connector.

Ask ChatGPT about live CurbWaste work.

Installed and configured for your team.

ChatGPT in Chrome answering a CurbWaste question for Ironwood East Resource Group

Which assets in CurbWaste should Ironwood East Resource Group pull into today’s maintenance call?

I found three assets where safety, service continuity, or avoidable cost is increasing:

  • Asset IER-7221 · service 312 miles overdue The unit is assigned to tomorrow’s Phoenix, AZ route and has two open brake-inspection alerts. Noah Williams is the recorded supervisor.
  • Asset IER-6679 · repeat temperature alarm The same threshold alert fired three times overnight. The prior ticket was closed as “monitor,” with no sensor test attached.
  • Asset IER-9458 · no activity for 19 hours It is marked active at the north yard but has not reported location or engine data since yesterday at 2:40 PM.

Remove IER-7221 from tomorrow’s route, reopen the alarm ticket with a sensor test, and have the yard verify IER-9458 before dispatch.

Claude version.

View Claude page →
Claude in Chrome answering a CurbWaste question for Ironwood East Resource Group

Which assets in CurbWaste should Ironwood East Resource Group pull into today’s maintenance call?

I found three assets where safety, service continuity, or avoidable cost is increasing:

  • Asset IER-7221 · service 312 miles overdue The unit is assigned to tomorrow’s Phoenix, AZ route and has two open brake-inspection alerts. Noah Williams is the recorded supervisor.
  • Asset IER-6679 · repeat temperature alarm The same threshold alert fired three times overnight. The prior ticket was closed as “monitor,” with no sensor test attached.
  • Asset IER-9458 · no activity for 19 hours It is marked active at the north yard but has not reported location or engine data since yesterday at 2:40 PM.

Remove IER-7221 from tomorrow’s route, reopen the alarm ticket with a sensor test, and have the yard verify IER-9458 before dispatch.

Setup included.

  1. 1Review
  2. 2Configure
  3. 3Connect + test