AIConnectors.io
ChatGPT logo
+

ChatGPT +
OASES connector.

Ask ChatGPT about live OASES work.

Installed and configured for your team.

ChatGPT in Chrome answering a OASES question for Copper Pine Coastal Fleet Services

Which assets in OASES should Copper Pine Coastal Fleet Services pull into today’s maintenance call?

I found three assets where safety, service continuity, or avoidable cost is increasing:

  • Asset CPC-6069 · service 312 miles overdue The unit is assigned to tomorrow’s Chicago, IL route and has two open brake-inspection alerts. Owen Carter is the recorded supervisor.
  • Asset CPC-3290 · repeat temperature alarm The same threshold alert fired three times overnight. The prior ticket was closed as “monitor,” with no sensor test attached.
  • Asset CPC-8306 · no activity for 19 hours It is marked active at the north yard but has not reported location or engine data since yesterday at 10:10 AM.

Remove CPC-6069 from tomorrow’s route, reopen the alarm ticket with a sensor test, and have the yard verify CPC-8306 before dispatch.

Claude version.

View Claude page →
Claude in Chrome answering a OASES question for Copper Pine Coastal Fleet Services

Which assets in OASES should Copper Pine Coastal Fleet Services pull into today’s maintenance call?

I found three assets where safety, service continuity, or avoidable cost is increasing:

  • Asset CPC-6069 · service 312 miles overdue The unit is assigned to tomorrow’s Chicago, IL route and has two open brake-inspection alerts. Owen Carter is the recorded supervisor.
  • Asset CPC-3290 · repeat temperature alarm The same threshold alert fired three times overnight. The prior ticket was closed as “monitor,” with no sensor test attached.
  • Asset CPC-8306 · no activity for 19 hours It is marked active at the north yard but has not reported location or engine data since yesterday at 10:10 AM.

Remove CPC-6069 from tomorrow’s route, reopen the alarm ticket with a sensor test, and have the yard verify CPC-8306 before dispatch.

Setup included.

  1. 1Review
  2. 2Configure
  3. 3Connect + test