AIConnectors.io
ChatGPT logo
+

ChatGPT +
Tekmetric connector.

Ask ChatGPT about live Tekmetric work.

Installed and configured for your team.

ChatGPT in Chrome answering a Tekmetric question for Northstar Prairie Fleet Services

Which assets in Tekmetric should Northstar Prairie Fleet Services pull into today’s maintenance call?

I found three assets where safety, service continuity, or avoidable cost is increasing:

  • Asset NPF-2822 · service 312 miles overdue The unit is assigned to tomorrow’s Columbus, OH route and has two open brake-inspection alerts. Mateo Ruiz is the recorded supervisor.
  • Asset NPF-5601 · repeat temperature alarm The same threshold alert fired three times overnight. The prior ticket was closed as “monitor,” with no sensor test attached.
  • Asset NPF-8380 · no activity for 19 hours It is marked active at the north yard but has not reported location or engine data since yesterday at 12:30 PM.

Remove NPF-2822 from tomorrow’s route, reopen the alarm ticket with a sensor test, and have the yard verify NPF-8380 before dispatch.

Claude version.

View Claude page →
Claude in Chrome answering a Tekmetric question for Northstar Prairie Fleet Services

Which assets in Tekmetric should Northstar Prairie Fleet Services pull into today’s maintenance call?

I found three assets where safety, service continuity, or avoidable cost is increasing:

  • Asset NPF-2822 · service 312 miles overdue The unit is assigned to tomorrow’s Columbus, OH route and has two open brake-inspection alerts. Mateo Ruiz is the recorded supervisor.
  • Asset NPF-5601 · repeat temperature alarm The same threshold alert fired three times overnight. The prior ticket was closed as “monitor,” with no sensor test attached.
  • Asset NPF-8380 · no activity for 19 hours It is marked active at the north yard but has not reported location or engine data since yesterday at 12:30 PM.

Remove NPF-2822 from tomorrow’s route, reopen the alarm ticket with a sensor test, and have the yard verify NPF-8380 before dispatch.

Setup included.

  1. 1Review
  2. 2Configure
  3. 3Connect + test