AIConnectors.io
Claude logo
+

Claude +
ShipNet connector.

Ask Claude about live ShipNet work.

Installed and configured for your team.

Claude in Chrome answering a ShipNet question for Oak & Ember Atlantic Utilities

Which assets in ShipNet should Oak & Ember Atlantic Utilities pull into today’s maintenance call?

I found three assets where safety, service continuity, or avoidable cost is increasing:

  • Asset OEA-6509 · service 312 miles overdue The unit is assigned to tomorrow’s Chicago, IL route and has two open brake-inspection alerts. Priya Shah is the recorded supervisor.
  • Asset OEA-3730 · repeat temperature alarm The same threshold alert fired three times overnight. The prior ticket was closed as “monitor,” with no sensor test attached.
  • Asset OEA-8746 · no activity for 19 hours It is marked active at the north yard but has not reported location or engine data since yesterday at 10:10 AM.

Remove OEA-6509 from tomorrow’s route, reopen the alarm ticket with a sensor test, and have the yard verify OEA-8746 before dispatch.

ChatGPT version.

View ChatGPT page →
ChatGPT in Chrome answering a ShipNet question for Oak & Ember Atlantic Utilities

Which assets in ShipNet should Oak & Ember Atlantic Utilities pull into today’s maintenance call?

I found three assets where safety, service continuity, or avoidable cost is increasing:

  • Asset OEA-6509 · service 312 miles overdue The unit is assigned to tomorrow’s Chicago, IL route and has two open brake-inspection alerts. Priya Shah is the recorded supervisor.
  • Asset OEA-3730 · repeat temperature alarm The same threshold alert fired three times overnight. The prior ticket was closed as “monitor,” with no sensor test attached.
  • Asset OEA-8746 · no activity for 19 hours It is marked active at the north yard but has not reported location or engine data since yesterday at 10:10 AM.

Remove OEA-6509 from tomorrow’s route, reopen the alarm ticket with a sensor test, and have the yard verify OEA-8746 before dispatch.

Setup included.

  1. 1Review
  2. 2Configure
  3. 3Connect + test