AIConnectors.io
Claude logo
+

Claude +
Tekion connector.

Ask Claude about live Tekion work.

Installed and configured for your team.

Claude in Chrome answering a Tekion question for North Harbor Prairie Fleet Services

Which assets in Tekion should North Harbor Prairie Fleet Services pull into today’s maintenance call?

I found three assets where safety, service continuity, or avoidable cost is increasing:

  • Asset NHP-7445 · service 312 miles overdue The unit is assigned to tomorrow’s Richmond, VA route and has two open brake-inspection alerts. Mateo Ruiz is the recorded supervisor.
  • Asset NHP-2429 · repeat temperature alarm The same threshold alert fired three times overnight. The prior ticket was closed as “monitor,” with no sensor test attached.
  • Asset NHP-5208 · no activity for 19 hours It is marked active at the north yard but has not reported location or engine data since yesterday at 9:30 AM.

Remove NHP-7445 from tomorrow’s route, reopen the alarm ticket with a sensor test, and have the yard verify NHP-5208 before dispatch.

ChatGPT version.

View ChatGPT page →
ChatGPT in Chrome answering a Tekion question for North Harbor Prairie Fleet Services

Which assets in Tekion should North Harbor Prairie Fleet Services pull into today’s maintenance call?

I found three assets where safety, service continuity, or avoidable cost is increasing:

  • Asset NHP-7445 · service 312 miles overdue The unit is assigned to tomorrow’s Richmond, VA route and has two open brake-inspection alerts. Mateo Ruiz is the recorded supervisor.
  • Asset NHP-2429 · repeat temperature alarm The same threshold alert fired three times overnight. The prior ticket was closed as “monitor,” with no sensor test attached.
  • Asset NHP-5208 · no activity for 19 hours It is marked active at the north yard but has not reported location or engine data since yesterday at 9:30 AM.

Remove NHP-7445 from tomorrow’s route, reopen the alarm ticket with a sensor test, and have the yard verify NHP-5208 before dispatch.

Setup included.

  1. 1Review
  2. 2Configure
  3. 3Connect + test